Handle Position; Moving The Machine - Husqvarna FS5000 D Operator's Manual

Handle position

CAUTION! Never use the handlebars to lift the saw.
Use the handlebars to maneuver the saw.
The position of the handlebars can be adjusted in height and
length.
• Loosen the lock knob A to adjust the length.
• Turn handle adjustment locking knob B counterclockwise
to unlock and reposition handlebar. Turn clockwise to lock
handlebar in position. Set handle to most comfortable
working height. Tighten the locking knob.
18 –
English
OPERATING
B
A

Moving the machine

Prior to moving the machine, read and understand section
"Starting and stopping".
Moving the machine with the engine off
• Turn Engine start switch to the ignition on position.
• Raise the saw by pressing up the Raise/lower switch on
the Speed control lever until the blade (if installed) clears
the pavement surface.
• Put Speed control lever into the STOP position.
• Set the Transmission bypass valve counterclockwise to
the up (neutral) position.
• The saw can now be moved by standing behind it and
pushing (while holding the handlebars).
WARNING! Do not attempt to push the saw
!
while it is in neutral position on a grade (or
hill). The saw operator could lose control of
the saw and cause injury to oneself or other
persons in the area.