Blade Depth Stop - Husqvarna FS5000 D Operator's Manual

• Tighten the blade shaft bolt firmly using the blade shaft
wrench while resistance between diamond blade and
ground helps to achieve proper and final tightening.
• Lower blade guard front and position the blade guard latch
on the blade guard front bolt. Tighten the blade guard front
bolt.
NOTICE! Do not operate this saw without the latch engaged
and the bolt installed. Do not use if damaged.
• Test run the machine and check that no unusual sounds
occur. Unusual sounds are a sign of an incorrectly
mounted blade.
Install the blade guard
Slip on blade guards are secured with a blade guard lock
which engages the rear half of the blade guard.
Do not operate this saw without the lock engaged. Inspect
blade guards and locks frequently. Do not use if damaged.
Different number of support spades are in use depending on
the size of the blade guard which is used.
Lower the guard onto the support spade(s) and use moderate
force to press down the blade guard until lock engages.
• 14", 20" and 26" guards are lowered on only one spade B.
• 30" guard is lowered on two spades B and C.
• 36" and 42" guards are lowered on three spades A, B and
C.
C
B
A
OPERATING
Remove the blade guard
1 Disconnect the water hose from the blade guard.
2 Use the blade shaft wrench, turn the blade guard lock
forward until it stops and unlatches. Lift at the same time
the blade guard with its handle off the support spade(s).

Blade depth stop

The saw is equipped with a Blade depth stop on the control
panel. When activated, the cutting depth will stop at the
cutting depth chosen by the operator.
For more information about maximum cutting depth for
different blade sizes, see section "Blades"
Setting the cutting depth
NOTICE! Only saw as deep as the job specifications require
since deeper sawing can cause structural strength
problems.
• Activate the Blade depth stop on the control panel.
2
2
1
2
1 3
4
<1200 RPM
12 80
10 14 60 100
WORKING HOUR
8 16 40 120
V V c c
CURRENT: STOP:
0 4
cm cm
– 21
English