Table of Contents
Advertisement
Check air cleaner restriction indicator.
•
Check and clean the outer air filter if the air cleaner
indicator is red, remove the rear cover by opening the 3 air
filter housing clamps and pulling the housing off.
•
Clean the filter by blowing the element from inside out.
Use the lowest possible air pressure to remove the dust
without damaging the element.
Use 0,29-0,49 MPa;3,0-5,0 kgf/cm
compressed air to remove particulates.
NOTICE! Do not exceed recommended air pressure. A
higher air pressure will damage the air filter.
•
Replace any damaged filters or gaskets and check air
hose and clamps for damages or looseness. Tighten or
replace as required.
NOTICE! No need to clean the inner filter on a daily basis.
The 3 air filter housing clamps can not be closed unless the
outer air filter is properly installed.
Protection covers
•
Make sure all protection covers are in place and in good
condition.
For more information, see the "Machine's safety equipment"
section.
Drain cooling water from gearbox to prevent rust
and/or freeze damage.
•
To drain water from gearbox, turn the drain tap
counterclockwise to open and clockwise to close.
MAINTENANCE AND SERVICE
2
(42-47 PSI)
Check the water spray over the diamond blade.
•
Raise blade guard front and use quick release pin to lock
it in upright position.
•
Open the Water valve on the control panel. Start the water
pump. Make sure it is straight jets of water from the two
nozzles. If nozzles are blocked, remove the quick
disconnect hose and clean hose and nozzles with
compressed air.
•
Replace nozzle or hose if damaged.
Drain fuel filter water separator from water
•
Drain the fuel filter water separator by using the hose in
the bottom. Put the hose in a bottle or a can, loosen the
drain tap and drain any water collected inside the
separator.
NOTICE! Treat this water as fuel and dispose properly.
– 33
English
Advertisement
Chapters
Table of Contents
Troubleshooting
