Power Management; Direct On; Standby Mode - Panasonic PT-VX400 Operating Instructions Manual

Subpicture size
J
1 ) Press ▲▼ to select [Subpicture size]
and then press the <SELECT> button.
2 ) Press ▲▼ to select one among the
items as below.
You can change the subpicture size among
z
Small, Middle and Large.
Subpicture position
J
1 ) Press ▲▼ to select [Subpicture
position] and then press the <SELECT>
button.
2 ) Press ▲▼ to select one among the
positions as below.
You can adjust the subpicture position. (the
z
bottom right, the top right, the top left and the
bottom left).
Attention
[Subpicture size] and [Subpicture position] works only
z
under P IN P mode.
The P IN P function is not available depending on the
z
input signals and the selected input terminals.
When the input signal(s) is/are incompatible,
z
be displayed on the Main/Sub picture.

Power management

For reducing power consumption as well as
maintaining the lamp life, the Power management
function turns off the projection lamp when the
projector is not operated for a certain period.
1 ) Press ▲▼ to select [Power
management].
2 ) Press ► or the <SELECT> button to
access the submenu.
Mode
J
1 ) Press ▲▼ and then press the
<SELECT> button to select one mode
among the items as below.
Ready When the lamp has been fully cooled
down, the <POWER> indicator
changes to green blinking. In this
condition, the projection lamp will
be turned on if the input signal is
reconnected or any button on the
control panel or remote control is
pressed.
Shut When the lamp has been fully cooled
down down, the power will be turned off.
Off [Power management] function is off.
Timer
J
1 ) Press ▲▼ to select [Timer] and then
press the <SELECT> button.
2 ) Press ▲▼ to set the Timer(1~30min).

Direct on

1 ) Press ▲▼ to select [Direct on] and
then press the <SELECT> button.
2 ) Press ▲▼ to switch between On and
Off.
When this function is set to [On], the projector
z
will be automatically turned on just by
connecting the AC power cord to a wall outlet.
Be sure to turn off the projector properly. If the
z
projector is turned off in the incorrect sequence,
the [Direct On] function does not work properly.
mark will
X

Standby mode

This function can set the electric power when the
projector is standing by.
1 ) Press ▲▼ to select [Standby mode]
and then press the <SELECT> button.
2 ) Press ▲▼ to switch between the items
as below.
Network
Note
When selecting [Network], the cooling fans may be
z
running depending on the temperature inside the
projector even if the projector is turned off.
Refer to "Operating Instructions - Network Operations
z
If Standby mode is set to [Eco], you cannot use network
z
functions when the projector is standing by. Also, you
cannot use some RS-232C protocol commands.
If set to [Network], you can use network functions when
z
the projector is standing by.
Restricts some functions in
Eco standby mode to reduce power
consumption.
Does not restrict functionality
even in standby mode.
Setting
".
53
ENGLISH -