Hdmi Setup; Terminal; P In P (Pt-Vw330E Only) - Panasonic PT-VX400 Operating Instructions Manual

Setting
Logo PIN code change
J
Logo PIN code can be changed to your desired four-
digit number.
1 ) Press ▲▼ to select [Logo PIN code
change].
2 ) Press the <SELECT> button.
Current logo PIN code dialog box appears.
z
3 ) Press ▲▼ to enter the current code.
The New Logo PIN code input dialog box
z
appears. Set a new Logo PIN code, a
confirmation box appears, choose [Yes] to set
the new Logo PIN code.
Attention
Be sure to note the new Logo PIN code and keep it on
z
hand. If you lost the number, you could no longer change
the Logo PIN code setting.

HDMI setup

This function is only used for HDMI input source.
1 ) Press ▲▼ to select [HDMI setup].
2 ) Press ► or the <SELECT> button.
The names for the output setting of Digital R/G/
z
B vary from equipment to equipment.
Image
J
Normal When the output of Digital R/G/B
equipment is set to Standard.
Enhanced When the output of Digital R/G/B
equipment is set to Enhanced.
Sound
J
When Digital input source is input,
HDMI
Sound is set to HDMI.
When DVI input source is changed
Computer
to HDMI input source, Sound is set
2
to Computer 2.
Attention
For details, refer to the operating instructions of your
z
Digital R/G/B equipment.
52
- ENGLISH

Terminal

The COMPUTER IN 2/MONITOR OUT terminal on
the back of the projector is switchable for computer 2
input or monitor output.
1 ) Press ▲▼ to select [Terminal] and
then press the <SELECT> button.
2 ) Press ▲▼ to switch the item.
Computer 2 Computer input
Monitor out Monitor out
Note
Terminal function is not available when selecting
z
[Computer 2] to the input source. Change the input
source to the others (HDMI or Computer 1 or Video) so
that the Terminal function will be available.

P IN P (PT-VW330E Only)

This function is used to project two images
simultaneously by placing a separate small sub
screen within or next to the main screen.
1 ) Press ▲▼ to select [P IN P].
You can also press the <P IN P>button on the
z
remote control to display [P IN P] menu
2 ) Press ► or <SELECT> button to
access the submenu.
Only the sound from the source of Main picture
z
is valid, while the source of Sub picture cannot
output the sound.
Mode
J
1 ) Press ▲▼ to select [Mode] and then
press the <SELECT> button.
2 ) Press ▲▼ to select one mode among
the items as below.
P IN P Provide the images of Main picture
and Sub picture at the ratio of
Screen aspect in the Screen Menu.
Side by Provide the images of Main picture
Side and Sub picture at the ratio of 4:3.
Off Turn off the P IN P function.
Attention
In [P IN P] the larger picture is main picture, and the
z
smaller one is sub picture; in [Side by side], the left
picture is main picture, and the right one is sub picture.