Replacing The Lamp Unit - Panasonic PT-VX400 Operating Instructions Manual

Replacing the Lamp unit

J
CAUTION:
When the projector is mounted on a ceiling, do not work with your face close to the projector.
z
Attach the lamp unit and the lamp cover securely.
z
When you experience difficulty in installing the lamp, remove it and try again. If you use force to install the
z
lamp, the connector may be damaged.
1 ) Turn off the Power by following the procedure
in "Turning off the projector (
Unplug the AC power cord. Wait at least 45
minutes and make sure the lamp unit and
surroundings are cool.
2 ) Use a Phillips screwdriver to loosen the
lamp cover fixing screw and remove the
lamp cover.
Remove the lamp cover by pulling it slowly toward
z
the direction of the arrow.
3 ) Use a Phillips screwdriver to loosen the
three lamp unit fixing screws until the
screws turn freely. Hold the used lamp
unit by its handles, and pull it gently from
the projector.
4 ) Insert the new lamp unit in correct
direction. Tighten the three lamp unit
fixing screws securely with a Phillips
screwdriver
5 ) Attach the lamp cover, and tighten the
lamp cover fixing screw securely with a
Phillips screwdriver.
Attach the lamp cover by pushing it slowly opposite
z
the direction of the arrow.
Note
When you replace the new lamp unit (ET-LAV100), the projector resets the total usage time of the lamp unit automatically.
z
page 28).
Æ
Replacement
Lamp cover
Lamp cover
fixing screw
Handles
Lamp unit
Lamp unit fixing screws
ENGLISH -
63