Installing Accessories; Transition Module - Emerson MVME4100 Installation And Use Manual

Hardware Preparation and Installation
2. The VME SCON SEL switch is OFF to select non-SCON mode. The switch is ON to select always SCON mode. This
switch is only effective when the VME SCON MAN switch is ON.
If you are installing the optional MVME7216E transition module, refer to
page 48 for configuration switch settings.
2.5

Installing Accessories

This section describes the procedures for installing the MVME7216E transition module, PMCs,
and the XMCspan on the base board.
2.5.1

Transition Module

The MVME7216E does not support hot swap. You should remove power to the rear slot or
system before installing the module. Before installing the MVME7216E transition module, you
may need to manually configure the switch and install a PMC I/O Module (PIM). Refer to
Chapter 5, Transition
Damage of Circuits
Electrostatic discharge and incorrect installation and removal can damage circuits or
shorten their life.
Before touching the board or electronic components, make sure that you are working in an
ESD-safe environment.
Product Damage
Only use injector handles for board insertion to avoid damage to the front panel and/or PCB.
Deformation of the front panel can cause an electrical short or other board malfunction.
Board Malfunction
Switches marked as "reserved" might carry production-related functions and can cause the
board to malfunction if their setting is changed.
Do not change settings of switches marked as "reserved". The setting of switches which are
not marked as "reserved" has to be checked and changed before board installation.
48
Module, for switch settings and PIM installation.
MVME4100 Single Board Computer Installation and Use (6806800H18D)
Transition Module on