Ethernet Connectors (J4A/J4B); Pci Mezzanine Card (Pmc) Connectors (J11 - J14, J21 - J23); Table 3-4 Ethernet Connectors (J4A/J4B) Pin Assignments; Table 3-5 Pmc Slot 1 Connector (J11) Pin Assignments - Emerson MVME4100 Installation And Use Manual

Controls, LEDs, and Connectors
3.3.3.2

Ethernet Connectors (J4A/J4B)

There are four 10/100/1000 Mb/s full duplex Ethernet interfaces using the MPC8548E Triple
Speed Ethernet Controllers (TSECs). Two Gigabit Ethernet interfaces are routed to the two
front-panel RJ-45 connectors with integrated LEDs for speed and activity indication. The other
Gigabit Ethernet interfaces are routed to P2 for rear I/O. These connectors use standard pin
assignments and are as follows:

Table 3-4 Ethernet Connectors (J4A/J4B) Pin Assignments

Pin #
1
2
3
4
5
6
7
8
3.3.3.3 PCI Mezzanine Card (PMC) Connectors (J11 — J14, J21 — J23)
There are seven 64-pin SMT connectors on the MVME4100 to provide 32/64-bit PCI interfaces
and P2 I/O for one optional add-on PMC.
PMC slot connector J14 contains the signals that go to VME P2 I/O rows A, C, D, and Z. The pin
assignments for these connectors are as follows:

Table 3-5 PMC Slot 1 Connector (J11) Pin Assignments

Pin
1
3
5
7
64
10/100/1000 Mb/s
_DA+
_DA-
_DB+
_DC+
_DC-
_DB-
_DD+
_DD-
Signal
TCK
GND
INTB#
PMCPRSNT1#
MVME4100 Single Board Computer Installation and Use (6806800H18D)
Signal
-12V
INTA#
INTC#
+5V
Pin
2
4
6
8