N-E Color Wash USER MANUAL Table of Contents Safety Information……………………………………………………………………………………………. 3 Specifications…………………………………………………………………………………………………….. 4 Main Power Connection………………………………………………………………………………….. 5 DMX-512 Connection…………………………………………………………………...……………..5 Rigging the Fixture…………………………………………………………………………………………….9 DMX Profile......................... 6 Main Control Menu......................7 Cleaning & Maintenance....................9 Parts List..........................9...
Page 3
Check that the unit has not been damaged during transport Protection Against Fire 1. Maintain a minimum of 1 foot distance from any type of flame. 3. Replace fuse only with the specified type and rating. 4. Do Not install the unit to close to a heat source. 5.
Technical Information Part Numbers Fixture 4040– N-E Color Wash Mechanical Specifications DMX Connectors: 3-pin XLR connectors 5 ” 16.75 ” Power Connection: Thermal: Maximum ambient temperature 40° C Maximum surface temperature 60° C Fastening System: Mounting Yoke 3.5 ” 6.5 ”...
Main Power Connection Caution! Do not connect fixture to a dimmer system. This unit has Auto switching power supply. It will respond to 110V or 220V automatically This unit must be earthed. (electronically grounded) Replace fuse only with the specified type and rating. The occupation of the connection-cable is as follows: 110V Connection Cable (USA)
10 times the weight for 1 hour with out any harming. Installation should be checked at least one time a year by a skilled person. DMX Profile N-E Color Wash DMX Chanel Function...
Main Control Menu The control board on the fixture base is your interface to access and control all the functions on the unit. Its dipswitch interface gives you a code view of the op- tions. The following will explain each function and its 6 7 8 9 10 options.
Cleaning and maintenance Installation Maintenance: The operator has to make sure that the unit is operating safely and has the installations and electron- ics checked by an expert every 2 years. The following points have to be considered during the inspection: 1) All screws used for installing the device or part of the device have to be tightly connected and must not be corroded.
Page 9
Mega-Lite 5718 Kenwick St San Antonio, TX 78238 Ph 210-684-2600 Fax 210-855-6279 www.mega-lite.com / info@mega-lite.com...
Need help?
Do you have a question about the N-E Color Wash and is the answer not in the manual?
Questions and answers