To ensure the appliance If an extension cable is used, Water connection safety only use original spare the plug and the socket must be Connection to the public parts from the manufacturer waterproof and comply with the mains according to regula- or approved by the manufac- below-mentioned requirements tions.
® 2.2 Operation elements See foldout at the end of this 9 Click & Clean Powerspeed and model survey manual. nozzle 10 Click & Clean foam sprayer 1 Start/stop switch 11 Nozzle cleaning tool 2 Water inlet with fi lter (2a) 12 Trolley handle 3 High pressure connection 13 Hose hook...
3.3 Mounting of high 1. Attach the high pressure pressure hose hose (4) to the spray gun (7). Detach the high pressure hose by pressing the pawl (A). 4 Operating your pressure washer 4.1 Connection of high 1. Mount the high pressure pressure hose hose on the outlet (3).
Page 7
4.3 Water connection An ordinary 1/2" garden hose IMPORTANT! Only use wa- of min. 5 m and max. 25 m will ter without any impurities. If be suitable. there is a risk of running sands in the inlet water (i.e. from your own well), an additional fi...
fi lter should be mount ed. For 3. Start the machine. further in for ma tion, please 4. Detach the spray lance contact your near est Gerni and activate the trigger of dis trib u tor. 4.6 Pressure regulation on The pressure can be regulated ®...
Page 9
5.2 Typical fi elds of application Below you will fi nd a description of a lot of cleaning tasks which can be solved by a pressure washer from Gerni in association with accessories and detergents. Task Accessories ‘Click Cleaning method &...
6 After using your pressure washer 6.1 Storing the washer The machine should be 3. Stop the machine, unplug stored in a frost-free room! and wind up hose and cable. 4. Place spray handle, nozzles Pump, hose and accessories and other accessories in the should always be emptied of holders of the machine.
7 Maintenance WARNING! Always disconnect Wash out water hose, high the electrical plug from the pressure hose, spray lance socket prior to maintenance or and accessories before cleaning. mounting. Clean the connectors of dust To ensure a long and problem and sand.
Page 12
7.2 Cleaning of nozzle A clogging up in the nozzle causes a pump pressure which is too high. This is why cleaning is required immediately. 1. Stop the machine and dis- connect the nozzle. 2. Clean the nozzle. IMPOR- TANT: The cleaning tool (11) should only be used when the nozzle is detached! 3.
No water supply Connect inlet water. Water fi lter blocked Clean the fi lter (see section 7.1) Nozzle blocked Clean the nozzle (see section 7.2) In case problems other than the above occur, please contact your local Gerni distributor.
Contact your local authorities or your nearest dealer for further information. 9.2 Warranty conditions Gerni guarantees high pres- that only water without any sure washers for domestic use impurities has been used. for 2 years. If your high pres-...
For removal of paint and rust. Sand available from do-it-yourself blasting equip- shops. ment Patio Washer Equipment for quick cleaning of patio/drive/fl agstones. 10 Main Technical Data Type Classic 120.1 Rated pressure 10.0 Permissible pressure max. 12.0 Rated flow l/min Rated input 1.65...
Name of the person responsible for the technical Wolfgang Nieuwkamp documentation Description of the equipment: High pressure washer Equipment name Gerni Model Classic 120.1 Dimension 280 x 270 x 820 mm Rated output voltage AC 230-240 V Rated frequency 50 Hz Rated input power 1.65 kW...