Epson EPL-N2700 Reference Manual page 160

Print Overrun
The time required to process data exceeds the print engine speed
because the volume of data is too great. Press Continue to resume
printing. If this message appears again, change the Page Protect
setting in the SelecType Config Menu.
Ready
The printer is ready to receive data and print.
Remove Output Paper
This messages appears when the Multibin Mode setting has been
changed and paper remains in an optional multibin unit. Remove
all the paper in the multibin unit.
Reset
The printer's current interface has been reset and the buffer is
cleared. However, other interfaces are still active and retain their
settings and data.
Reset All
All printer settings have been reset to the user default
configuration, or to the last settings that were saved.
Reset to Save
You have changed the SelecType setting but the new setting was
not activated immediately after exiting SelecType. To activate the
new setting, do one of the following: 1) exit SelecType by pressing
Continue or On Line (the new setting is activated after the current
print job is finished), or 2) reset the printer by pressing ALT and
Reset at the same time.
ROM Check
The printer is checking the ROM.
6-26
Troubleshooting