Hiniker 700 Operator's Manual page 9

the lift frame to fall forward, possibly causing
personal injury or damage to plow components.
With the plow lowered to the ground and the con-
troller in the "float" mode, push down on the up-
per lift links to fully retract the lift cylinder rod.
Retract Cylinder With Upper Lift Links
Rotate the stop plate up to contact the spacer
bushing on the lift cylinder bolt.
Rotate Stop Plate
Gently push back on the headlight bracket to tilt
the lift frame back as far as possible, then release
the bracket to allow the weight of the lift frame to
lock the stop plate in place.
Push Lift Frame Back
Swing the latch handle open until the sliders are
fully removed from the attachment prongs.
DWG NO. 5693
Swing Handle to Remove Sliders
Lower the parking stand to the ground by remov-
ing the tab lock pin from the front hole in the push
frame, then swinging the stand to the ground with
the lever.
DWG NO. 5695
Lower and Pin Parking Stand
Reinstall the pin through matching holes in the
stand lever and push frame to hold the stand in
place.
Operating Procedures 7
DWG NO. 5697
DWG NO. 5694
DWG NO. 5696