Hiniker 700 Operator's Manual page 18

16 Plow Assembly
The fitting in the LH side angling cylinder
may have to be adjusted slightly to route
the hydraulic hose to best avoid interfer-
ence with the latch handle and the lift links.
Use plastic tie straps to secure all hydraulic
hoses away from lift link stops.
6. Before assembling the headlamp brack-
ets on the lift frame tube, scrape a small
amount of paint from the three holes in each
bracket and from the four holes in the frame
tube to provide a good electrical ground for
the turn signals and parking lights.
Mount the headlamp brackets to the lift
frame tube with four 3/8 inch x 2 inch car-
riage bolts and flanged lock nuts from the
hardware bag in the parts box.
Remove the LH and RH headlamps from
their boxes and mount on the brackets with
hardware from the headlamp boxes.
Use plastic tie straps to band headlamp ca-
ble above and below the brackets at the lo-
cations shown to provide clearance for the
power unit cover later.
Refer to sections titled "System Check-Out"
and "Headlamp Aiming Procedure" in this
manual for aiming instructions.
7. Identify the plow power cable assembly
and plow wiring harness in the parts box. A
ground wire harness for the solenoids is in
the power unit box.
The power cable for the snowplow has two
cables with ring terminals on one end and
a two pin connector on the other and mea-
sures about 38" long.
NOTE: To prevent corrosion lightly coat all elec-
trical connections, ring and spade terminals with
dielectric grease prior to assembly.
DWG NO. 6489
The plow wiring harness has a 10-pin con-
nector on one end and the other end has
connectors labeled "DRIVER SIDE" and
"PSNGR SIDE" for the headlamps and four
loose wires with spade terminals.
The ground wire for the solenoid has one
wire 7 inches long and two wires 11 inches
long. There is a 1/4 inch ring terminal on the
common end and three spade receptacles
on the remaining ends.
Refer to drawing 6502. Attach the ring ter-
minal of the solid red (or red-striped) wire
of the power cable assembly to the terminal
on the power unit at location 1.
Fasten the ring terminal of the solid black
wire of the power cable assembly, the ring
terminal on the black wire of the plow har-
ness and the ring terminal of the solenoid
ground harness to the terminal on the motor
at location 2.
Connect the three black wires of the ground
harness to solenoids S1, S2 and S3.
Connect the gray wire from the wiring har-
ness to solenoid S1. S1 extends the right
side of the plow to plow left.
Connect the tan wire from the wiring harness
to solenoid S2. S2 extends the left side of the
plow to plow right.
Connect the blue wire from the wiring har-
ness to solenoid S3. S3 lowers the plow.
DWG NO. 6502