Hiniker 700 Operator's Manual page 17

Rotate the stop plate assembled to the push
frame up to contact the spacer bushing on
the lift cylinder bolt. Gently push back on
the upper lift frame tube, then release to al-
low the weight of the frame to lock the stop
plate in place.
5. Before assembling the power unit on the lift
frame, scrape a small amount of paint from
the two mount holes in the lift frame to pro-
vide a good electrical ground for the turn
signals and parking lights.
Mount the power unit on the lift frame with
two 3/8" x 3/4" hex bolts and two 3/8" lock
washers. The plastic reservoir of the power
unit should be to the left side of the plow.
Locate three 90
the hardware bag.
Turn the O-ring end of one adapter into the
top port of the power unit so that it points
about 45 to the right and to the rear when
O
viewed from the top.
DWG NO. 5700
DWG NO. 6484
O-ring/flare adapters in
O
Turn the other two 90
A and B from the back of the power unit so
that the flare ends point straight down.
Install 45 O-ring/flare adapters into the
O
ports of the angling cylinders so that the
flare ends of the adapters are directed
straight back.
Three identical hydraulic hoses are in the
parts box. Each hose has a swivel nut on
each end that will assemble to the adapters
from the power unit and three cylinders.
Connect one hose to the fitting from the
top of the power unit, then route the hose
ahead of the lift frame tube before assem-
bling to the fitting from the lift cylinder.
Connect the remaining two hoses to the fit-
tings from ports A and B at the back of the
power unit. Route both hoses ahead of the
lift frame tube before assembling the hose
from port A to the LH side angling cylinder
and the hose from port B to the RH side
angling cylinder.
Plow Assembly 15
adapters into ports
O
DWG NO. 5702
DWG NO. 6485