Remote Start Shutdown/Startup Diagnostics - Directed Electronics Viper 5601 Installation Manual

Remote Start Shutdown/Startup Diagnostics

Shutdown diagnostics: If the remote start activates but fails to stay running, the remote start module has the
ability to inform you of what may have caused the remote start failure. Before performing shutdown diagnos-
tics it is important that you let the remote start shut off on its own i.e. let it attempt to start 3 times then shut
down, if this is not done the unit will report the shutdown you used to shut off the remote start.
Note: Shutdown diagnostics does not report if the vehicles factory immobilizer is causing the problem.
To perform shutdown diagnostics:
1. With the ignition Off,
2. the ignition On and then back Off while holding the Control button.
Turn
3. Release the Control button.
4. Press and release the Control button. The status LED flashes to report the last shutdown for one minute or
until the ignition is turned on, as shown in the following table:
Status LED Flashes
1 flash
2 flashes
3 flashes
4 flashes
5 flashes
6 flashes
7 flashes
8 flashes
9 flashes
10 flashes
11 flashes
* Timer mode error: Ignition is on or shutdown input is active when activating timer mode.
Turbo mode error: Turbo mode is programmed off, engine is not on or shutdown input is active.
Manual mode error: MTS mode not enabled.
** Alarm was triggered during remote start sequence.
Startup Diagnostics: If the vehicle fails to activate the remote start, the remote start module will flash the park-
ing lights on the vehicle to notify you of what caused the no-start situation.
Parking Light Flashes
5 flashes
6 flashes
7 flashes
8 flashes
© 2009 Directed Electronics. All rights reserved.
press and hold the Control button (on Control Center).
Shutdown Mode
Runtime expired
Over-rev shutdown
Low or no RPM
Transmitter shutdown (or optional push button)
(+) Brake shutdown
(-) Hood shutdown
Timer mode/Turbo mode/Manual mode error *
Neutral safety shutdown
Low battery (voltage mode)
Alarm triggered **
Wait-to-start input timed out
Brake wire is active
Hood pin wire is active
Manual transmission mode is enabled and not initialized.
Neutral safety wire has no ground or the neutral safety switch is Off.
9