Directed Electronics Viper 5601 Installation Manual page 17

6. Turbo Mode
1. No turbo Mode: Turbo mode is not available
2. On – 1/3/5/10 minutes: Turbo Mode is available and, when activated, the engine will run for the
duration set per the selected option
7. Timer Mode Runtime
• 12/3/6/9 minutes: sets the runtime when the engine is started by the Timer Mode and SmartStart
features
8. Flex Relay Function
1. Ignition 2: the relay will emulate the Ignition 1 output during remote start
2. Accessory 2: the relay will emulate the Accessory 1 output during remote start
3. Starter 2: the relay will emulate the Starter output during remote start
9. Diesel Start Delay
1. Wait-to-start input: (-) input on the Grey/black (H2/7) WTS wire will delay the starter output until the
ground ceases.
2. Timed 15/30/45 seconds: delays the starter output per the selected option, the WTS wire does not
function.
10. Accessory during Diesel Start Delay
1. On: the Accessory outputs (H/3 high current and H2/12 low current) will be ON during diesel start
delay
2. Off: the Accessory outputs (H/3 high current and H2/12 low current) will be OFF during diesel start
delay
11. Status 2 Output (Dark Blue H2/10 wire)
1. Status: the output will activate before the ignition outputs turn on, and de-activate after they turn off
during remote start
2. Latch rear defogger: the output activates 10 seconds after start if the interior temperature is below
55F. It turns off after 10 minutes or upon remote start off
3. Pulse rear defogger: the output activates (for 800mS) 10 seconds after start if the interior temperature
is below 55F.
12. Parking Light Output
1. Constant: the lights will turn on solid during remote start
2. Pulsed: the lights will pulse on/off during remote start
3. Off: the lights will be off during remote start
13. Anti-grind Output
1. On: the high current starter relay will be activated during remote start as anti-grind protection.
2. Off: the high current starter relay will not be activated during remote start, no anti-grind protection
is available.
14. Tach Mode Starter Release
1. Normal: the starter output will release normally during cranking (50% of the learned tachometer
value)
2. Increase: the starter output will release later during cranking (at 35% of the learned tachometer
value)
3. Decrease: the starter output will release sooner during cranking (at 35% of the learned tachometer
value)
15. Vehicle Temp Auto Report
1. Off: the report during remote start is defeated
2. On: the report is sent every 2 minutes during remote start if the temperature has changed (+/-) 1
degree since the last report
16. Remote start Safelock
1. Off: the Door lock and Factory Alarm Re-arm outputs will maintain the current status (locked/un-
© 2009 Directed Electronics. All rights reserved.
17