[3D Settings] Menu; [3D Mode]; [3D Sync Output Delay] - Panasonic PT-RZ475U Operating Instructions Manual

[3D SETTINGS] menu

On the menu screen, select [3D SETTINGS] from the main menu, and select an item from the
sub-menu.
Refer to "Navigating through the menu" (x page 46) for the operation of the menu screen.
f After selecting the item, press asqw to set.
Note
f If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [LIGHT POWER] is set to [ECO2], [3D SETTINGS] cannot be selected.

[3D MODE]

Select a control method of the 3D eyewear for the 3D system in use.
1) Press as to select [3D MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DLP Link]
[3D SYNC]
[DLP Link + 3D SYNC]
[OFF]
Note
f When viewing 3D images, be sure to select the control method suitable for 3D eyewear in use.
f When viewing 3D images using VESA standard 3D eyewear, connect a compatible IR transmitter correctly.
f When [DLP Link] or [DLP Link + 3D SYNC] is selected in [3D MODE], the entire screen may look whity.
f When selecting [DLP Link + 3D SYNC] in [3D MODE], 3D eyewear that supports DLP Link may not operate properly due to influence of
control signals emitted from an IR transmitter, depending on installation environment. In such a case, try changing the installation location of
an IR transmitter or viewing location.

[3D SYNC OUTPUT DELAY]

Adjust the delay time if opening and closing timing of 3D eyewear shutter is not matched to the images. (when using VESA standard 3D
eyewear)
1) Press as to select [3D SYNC OUTPUT DELAY].
2) Press qw to switch the item.
[0us] - [25000us]
Note
f When [3D MODE] is set to [DLP Link] or [OFF], [3D SYNC OUTPUT DELAY] cannot be adjusted.
f Before adjusting [3D SYNC OUTPUT DELAY], display 3D images.
66 - ENGLISH
Chapter 4 Settings — [3D SETTINGS] menu
Select this when viewing 3D images using 3D eyewear that supports DLP Link.
Select this when viewing 3D images using VESA standard 3D eyewear.
Select this when viewing 3D images using both 3D eyewear that supports DLP Link and VESA
standard 3D eyewear.
Disables the control of 3D eyewear.
Sets in increments of 10 us.