Projector Body - Panasonic PT-RZ475U Operating Instructions Manual

Note
f The remote control can be used within a distance of about 15 m (49'2") if pointed directly at the remote control signal receiver. The remote
control can control at angles of up to ± 15° vertically and ± 30° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate properly.
f The signal will be reflected off the screen. However, the operating range may be limited from light reflection loss due to the screen material.
f If the remote control signal receiver directly receives strong light, such as fluorescent light, the remote control may not operate properly. Use
it in a place distant from the light source.
f The power indicator <ON (G)/STANDBY (R)> will flash if the projector receives a remote control signal.

Projector body

Front
1 2 3
4 5
Rear
8
Bottom
8
: Projection direction
1 Power indicator <ON (G)/STANDBY (R)>
Displays the status of the power.
2 Light source indicator <LIGHT>
Displays the status of the light source.
Chapter 1 Preparation — About your projector
6 7 4
5
8 9
9
15
Side
10 11
12 13
8
14
3 Temperature indicator <TEMP>
Displays the internal temperature status.
4 Adjustable feet
Adjusts the projection angle.
5 Remote control signal receiver
6 Projection lens
7 Shift cover
Inside the cover is the lens shift adjustment mechanism for
adjusting projection position.
8 Air intake port
9 Air exhaust port
10 Security slot
This security slot is compatible with the Kensington security
cables.
11 Connecting terminals (x page 24)
12 <AC IN> terminal
Connect the supplied power cord.
13 <MAIN POWER> switch
Turns on/off the main power.
14 Control panel (x page 24)
15 Burglar hook port
Attaches a burglar prevention cable, etc.
9
ENGLISH - 23