Panasonic PT-RZ475U Operating Instructions Manual page 83

Displaying [BRIGHTNESS CONTROL STATUS]
Display the brightness control status.
1) Press as to select [BRIGHTNESS CONTROL].
2) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL] screen is displayed.
3) Press as to select [BRIGHTNESS CONTROL STATUS].
4) Press the <ENTER> button.
f The [BRIGHTNESS CONTROL STATUS] screen is displayed.
[BRIGHTNESS CONTROL STATUS] screen display example
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[OFF]
The screen shows the status that the brightness control is disabled.
BRIGHTNESS CONTROL STATUS
MODE
PROJECTOR
RETURN
MENU
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[AUTO] and [LINK] is set from [GROUP A] to [GROUP D]
The screen shows the status of the brightness control of
synchronized projectors (up to eight units), including the projector
being controlled through the on-screen menu.
BRIGHTNESS CONTROL STATUS
LINK
PROJECTOR
1:
PROJECTOR2
2: PROJECTOR3
3:
4:
5:
6:
7:
UPDATE
MENU SELECT
1 Display the name of the projector.
2 Display the synchronized group.
3 Display the IP address of the projector.
4 Display the names and IP addresses of projectors in same
group detected over the network.
5 Display the status by color.
Green: There is an allowance for brightness correction.
Yellow: There is little allowance for brightness correction.
Red: There is a brightness control error.
Chapter 4 Settings — [PROJECTOR SETUP] menu
OFF
1
1
GROUP A
2
3
192. 168. 30. 2
192. 168. 30. 3
192. 168. 30. 4
4
5
7
8
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[AUTO] and [LINK] is set to [OFF]
The screen shows the status of the brightness control in one
projector
BRIGHTNESS CONTROL STATUS
LINK
PROJECTOR
RETURN
MENU
When [MODE] of [BRIGHTNESS CONTROL SETUP] is set to
[PC]
BRIGHTNESS CONTROL STATUS
MODE
PROJECTOR
RETURN
MENU
6 Display error detailed messages.
7 Display error messages.
When the message [Failed to apply BRIGHTNESS CONTROL
to some projectors.] appears, it means that synchronization with
the projector displayed in red has failed.
Press as to select the projector displayed in red, and press
the <ENTER> button to display the error details.
8 Update to the latest status information.
OFF
5
1
6
PC
5
1
6
ENGLISH - 83