Debug Settings And Data Collection Tools; Lsattr Tuning; Driver_Debug Setting; Ip_Trc_Lvl Setting - IBM pSeries Tuning Manual

5.0 Debug settings and data collection tools

Several debug settings and data collection tools can help you debug a performance problem on
systems using HPS. This section contains a subset of the most common setting changes and
tools. If a performance problem persists after you check the debug settings and the data that was
collected, call IBM service for assistance.

5.1 lsattr tuning

The lsattr command lists two trace and debug-level settings for the HPS links. The following
settings are recommended for peak performance and are the defaults.

5.1.1 driver_debug setting

The driver_debug setting is used to increase the amount of information collected by the HPS
device drivers. eave this setting set to default value unless you are directed to change it by IBM
service.

5.1.2 ip_trc_lvl setting

The ip_trc_lvl setting is used to change the amount of data collected by the IP driver. Leave this
setting set to default value unless you are directed to change it by IBM service.

5.2 CPUs and frequency

Performance of parallel application can be impacted by the number of CPUs on an LPAR and by
the speed of the processors. To see how many CPUs are available and the frequency they run at,
run any of the following commands:
lsdev -Cc processor
lsattr -E -l proc#
bindprocessor -q
prtconf
pmcycles –m
If you mix slow CPUs and fast CPUs within a parallel job, the slowest CPU determines the speed
for the entire job.
pshpstuningguidewp040105.doc
Parameter
driver_debug
ip_trc_lvl
Setting
0
0x1111
Page 19