Set Your Room And Dhw Charging Temperature - Danfoss C37 User Manual

Set your room and DHW
charging temperature
Go to display C.
Circuit I:
Setting the desired room temperature
2
Select the constant comfort mode.
Set the desired room temperature for the comfort
mode.
Select the constant setback mode.
Set the desired room temperature for the setback
mode.
Select the desired mode (section 2).
The setting of the desired room temperature is important even if
a room temperature sensor /room panel / remote control is not
connected.
Is the room temperature too low?
Make sure that the radiator thermostat does not limit the room
temperature.
If you still cannot obtain the desired room temperature by
adjusting the radiator thermostats, the flow temperature is too
low. Increase the desired room temperature.
Circuit II:
Setting the desired DHW charging temperature
7
Select the constant comfort mode.
Set the desired DHW charging temperature for
the comfort mode.
Select the constant setback mode.
Set the desired DHW charging temperature for
the setback mode.
Select the desired mode (section 2).
Desired room
temp. in
0
comfort mode
Desired DHW
charging temp. in
0
comfort mode
Desired room
temp. in
1 6
setback mode
Desired DHW
charging temp. in
1 0
setback mode
The yellow
side of the
ECL Card
3