Danfoss Type CFR User Manual

Room Thermostat
User Guide
Type CFR
Temperature setting
Set room temperature on the thermostat dial.
On the right-hand side of the thermostat is a
function switch with 3 possible settings:
The room temperature will be as set
on the thermostat.
¹
The control system must have a CFZ
programmer, put thermostat switch
into this position to engage the pro-
grammer. The temperature will be as
set on the room thermostat, but in ac-
cordance with the consumption pattern
entered.
The heating pattern in the programmer
can be overridden by moving the
switch to or .
The room temperature will be as set
on the thermostat less a setback of
5°C/9°F.
Warning: Changes or modifications to this unit not
expressly approved by the party responsible for
compliance could void the user's authority to operate
the equipment.
Limitation of the setting range
Behind the dial for temperature setting are two lock-
rings. These can be moved as shown if the thermo-
stat setting range is to be narrowed.
FCC ID: PGBTYPE-CFR , CAN 3934104209
This device complies with Part 15 of the FCC Rules and
with RSS-210 of Industry Canada:
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
(70°F)
Setback
5°C (9°F)