Check The Tire Pressure; Checklist - Husqvarna CZE 4818 Operator's Manual

TO ROLL THE MOWER OFF OF THE SKID
(See Operation section for location and
function of controls
• Move to the rear of the mower, and place the
IZT (Integraded Zeroturn Transaxle) bypass
linkages into the bypass position to
disengage the IZT's (See "TO TRANSPORT"
in the Operation section of this manual).
• Sitting on the mower, press the deck lift pedal
in to the highest cutting position.
• Release park brake lever.
• Roll the mower forward or backward off of the
skid.
TO DRIVE THE MOWER OFF OF THE
SKID (See Operation section for location
and function of controls)
WARNING
Before starting, read, understand and
follow all instructions in the Operation
section of this manual. Be sure the mower
is in a well-ventilated area. Be sure the
area in front of the mower is clear of other
people and objects.
• Be sure all of the above assembly steps
have been completed.
• Check engine oil level and fill fuel tank with
gasoline.
• Place the IZT bypass linkages into the drive
position (See "TRANSPORT" in the
Operation section of this manual).
• Sit on the seat in the operating position, set
the park brake lever to the on position.
• Rotate the control levers outward into the
neutral slot.
• Press forward on the deck lift pedal to raise
the deck into the highest cutting position.
• Place the throttle control into the choke position.
• Start the engine. After the engine has
started, move the throttle control to the idle
position.
• Release the park brake.
• Move the control levers into the operate position.
• Slowly move the control levers forward and
slowly drive the mower off of the skid.
• Return the control levers back to the neutral
position.
• Apply the park brake.
• Turn the ignition key to the "OFF" position.
ASSEMBLY

CHECK THE TIRE PRESSURE

Correct tire pressure is important for best cutting
performance.
• Check the tire pressure and adjust
accordingly. Refer to the "SPECIFICATIONS"
section in this manual.

CHECKLIST

PLEASE REVIEW THE FOLLOWING
CHECKLIST
• All assembly instructions have been
completed
• No remaining loose parts in crate
• Seat is adjusted properly and securely
fastened
• All tires are properly inflated
• Check wiring. See that all connections are
still secure, and wires are properly clamped.
• Before driving the mower, be sure the
IZT(Integraded Zeroturn Transaxle) bypass
linkages are in the drive position.
WHILE LEARNING HOW TO USE YOUR
MOWER, PAY EXTRA ATTENTION TO THE
FOLLOWING ITEMS:
• Engine oil is at proper level
• Fuel tank is filled with fresh, clean, regular
unleaded gasoline. Check your engine
manual for fuel requirements.
• Become familiar with all controls – their
location and function. Operate them before
you start the engine.
• Become familiar with unit operation on a flat
and level area with the mower deck shut off.
• Be sure the brake system is in a safe
operating condition. If adjustment is needed
see Service and Adjustment section.
14