Husqvarna CZE 4818 Operator's Manual page 18

TO ADJUST THE DECK CUTTING
HEIGHT (See Fig. 5)
The deck cutting height is obtained by pressing
the foot pedal forward to lift the deck. To lower
the deck, you apply pressure to the top side of
the foot pedal and allow it to pivot while
allowing the lift arm to rotate to the rear of the
unit. To stop in a desired cutting position, rotate
the foot pedal down into the notch in the height
plate. The cutting height range is from 1 1/2" to
4 1/2" in 1/2" increments. The heights are
measured from the ground up to the blade tip
with the engine not running.
• The average lawn should be cut to 2 1/2"
during the cool season and to over 3" during
the hot months. For healthier and better
looking lawns, mow often and after moderate
growth.
• For best cutting performance, grass over 6
inches in height should be mowed twice.
Make the first cut relatively high; the second
to the desired height.
OPERATION
3
18
1
FIGURE 5
1. FOOT PEDAL
2. LIFT ARM
3. HEIGHT PLATE
2
CZ-8