Check Tire Pressure - Husqvarna CTH2642TE Operator's Manual

BAGGER ADJUSTMENT (See Fig. 11)
For proper bag function and appearance, it may be nec es-
sary to adjust the bagger assembly. There should be 6mm
(1/4")-9mm (3/8") gap between the bagger top and fender
and the bagger top surface should be even with the top
surface of the fender. To adjust bagger position:
HORIZONTAL ADJUSTMENT
• Slightly loosen the nuts securing the bagger RH and LH
hor i zon tal adjustment brackets. Loosen only enough
so the brackets keep their position, but allow them to
be moved.
• Move the brackets the amount forward or back ward
you wish the bag assembly to move. Retighten the
nuts securely.
VERTICAL ADJUSTMENT
• Slightly loosen the nuts securing the vertical adjustment
brackets. Loosen only enough so the brackets keep
their position, but allow them to be moved.
• Move the brackets the amount up or down you wish the
bag assembly to move. Retighten the nuts securely.
• Reinstall the bagger as sem bly and check the bagger
to fender fit. If necessary, repeat the procedure until
proper fit is attained.
TOP SURFACES
EVEN
HOR I ZON TAL
AD JUST MENT
BRACKET
VERTICAL
AD JUST MENT
BRACK ET
ASSEMBLY
6MM (1/4") - 9MM (3/8")
02329
Fig. 11
TO ASSEMBLE AND INSTALL MULCHER
PLUG (See Fig. 8)
• Remove spring retainer and pin from handle.
• Insert plug into handle. Make sure that the letter "A"
on both the plug and handle are on the same side and
that they can both be seen from the top when laying
on the ground.
• Secure with pin and retainer spring provided. For in stal la-
tion see "To Convert Mower" in Section 5 of this manual.

CHECK TIRE PRESSURE

The tires on your tractor were overinflated at the factory
for shipping purposes. Correct tire pressure is important
for best cutting performance.
• Reduce tire pressure to PSI shown on tires.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be prop-
erly leveled. See "TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments
sec tion of this manual. Verify that the belts are routed
correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see that
the brake is operating properly. See "TO CHECK BRAKE"
in the Service and Adjustments section of this manual.
9
HAN DLE
RE TAIN ER
SPRING
PIN
PLUG
Fig. 8