Service And Adjustment; Mower; To Deck Level - Husqvarna CZE 4818 Operator's Manual

Hide thumbs Also See for CZE 4818:

Operator's manual (40 pages)

Table Of Contents

Table of Contents

WARNING

BEFORE PERFORMING ANY SERVICE

OR ADJUSTMENTS:

• Set park brake to engaged position.

• Place PTO switch in the disengaged

position (pressed down).

• Turn ignition key "OFF" and remove the

key.

• Make sure the blades and all moving

parts have completely stopped.

• Disconnect spark plug wire from spark

plug and place the wire where it cannot

come in contact with the plug.

MOWER

TO LEVEL DECK

Adjust the deck while the mower is on a level

surface. Make sure the tires are inflated to the

correct pressure (see "SPECIFICATIONS"

section in this manual). If tires are under or over

inflated, you can not properly adjust your deck.

NOTE:

It may be easier to adjust the front lift

linkages by removing the floor pan before any

adjustments are made

SIDE-TO-SIDE ADJUSTMENT (See Figs.

13 and 14)

• Raise the deck into the highest cutting

position (4 1/2")

• Measure height from the bottom edge of the

deck to the ground at both front corners.

Distance "A" at both corners should be the

same.

• If adjustment is necessary, make adjustment

to one side the deck only

• To raise one side of the deck, using a 9/16"

wrench, tighten the hex nuts on both the front

and rear lift linkages (be sure to tighten equal

amounts).

• To lower one side of the deck, reverse

previous step.

• Recheck measurements after adjustment.