Table of Contents
Advertisement
FRONT-TO-BACK ADJUSTMENT
(See Fig. 15).
IMPORTANT: DECK MUST BE LEVEL SIDE-
TO-SIDE. IF THE FOLLOWING FRONT-TO-
BACK ADJUSTMENT IS NECESSARY, BE
SURE TO ADJUST BOTH FRONT OR BOTH
REAR LINKAGES EQUALLY SO THE DECK
WILL STAY LEVEL.
To obtain the best cutting performance, the
deck should be adjusted so the front tip of the
blades are approximately 1/8" to 1/4" lower than
WARNING
Blades are sharp. Protect your hands
with gloves and/or wrap blades with a
heavy cloth when handling.
Check adjustment on the right side of the
mower. Position any blade so that the tip is
pointing straight forward. Measure distance "B"
at the front and rear tip of the blade.
• Before making any necessary adjustments,
check to make sure that the deck is level
side-to-side.
• With the deck in the highest cutting position,
(4 1/2") measure the front tip of the blade to
see if the deck is higher or lower than 4 1/2".
• To lower the front tip of the blade, using a 9/
16" wrench, loosen the hex nuts that are on
the front lift linkages (be sure to loosen equal
amounts).
• When distance "B" is 1/8" to 1/4" lower at the
front than rear the adjustment is done.
• Reverse above step to raise the deck.
SERVICE AND ADJUSTMENT
B
30
B
FIGURE 15
CZ-19
Hide quick links:
Advertisement
Table of Contents
