Using Your Steam & Spray
Frequently Asked Questions
Q. My Steam & Spray
Mop leaves a foam on hard
™
floors.
A. The Steam & Spray Mop
Pad is likely too saturated. Replace it with a
clean, dry pad.
Q. My floors appear cloudy after cleaning.
A. The Steam & Spray
be dirty. Change the pad.
OR
A. The Steam & Spray
washed with a powder detergent and may be
damaged and require replacement. Never use
powder detergents. Only use liquid detergent
to launder the cleaning pads.
OR
A. The Steam & Spray
left in the same spot for too long with a wet
cleaning pad. Never leave the unit with a wet
pad in one spot for too long.
OR
A. This may be leftover from past cleaners that
were used on the floor surface. Use the Steam
& Spray
Mop a few more times and see if the
™
leftover cloudiness is removed. If this does not
work, we suggest rinsing the floor with water
and letting it dry. One or more rinses generally
removes the residue. A more stubborn case
may require you to rinse the floor with a mix
of one part vinegar to 2 parts water. Then use
the Steam & Spray
pad.
6
TOLL FREE: 1-800-798-7398
Mop - cont'd
™
Washable Cleaning
™
Mop Cleaning Pad may
™
™
Mop Cleaning Pad was
Mop may have been
™
Mop again with a clean
™
General Tips:
•
Change the Cleaning Pad frequently for best
results.
•
Always vacuum floors before cleaning or
polishing.