Using Steam; Using The Steam Energized; Cleanser - Shark SK410 series Owner's Manual

fig. 10

Using Steam:

1 Turn the steam locking collar to the "Steam &
Spray" position. (Fig. 9)
2 W ait 30 seconds for the boiler to heat the water.
Pump the handle a few times to prime the pump,
activate steam and moisten the cleaning pad.
(Fig. 10)
3 C lean your floors with a forward and backward
motion to customize steam output automatically.
(Fig. 11)
WARNING: Never stand on the Steam &
Spray Mop.
™
4 When the water tank is empty, the steam mop
will stop producing steam. You can refill the
water tank at any time as long as the mop is
unplugged from the electrical outlet. Follow
instructions on page 4.
IMPORTANT: The Steam & Spray Mop
be plugged in to use the steam function.
Steam
&
Spray
fig. 9
fig. 11
must
™
fig. 12
fig. 13

Using the Steam Energized

1 Make sure that the batteries are inserted into
the battery compartment behind the Cleanser
Bottle to use the spray function. See page 3.
2 Press the Spray Button to apply solution onto the
floor that is to be cleaned. (Fig. 12, Fig. 13)
3 If the Cleanser Bottle is empty, you can replace it
at any time as long as the unit is unplugged from
the electrical outlet.
IMPORTANT: Never leave the Steam & Spray
Mop with a damp/wet cleaning pad on any
floor surface for any amount of time as this may
damage the floor.
4 Once finished, step on the tab of the cleaning
pad and lift the unit to remove the cleaning pad.
NOTE: If you wish to use the Steam Energized
Cleanser without steam, turn the steam locking
collar to the "Spray Only" position. This will prevent
the handle from pumping and activating the pump.
(Fig. 14)
www.sharkclean.com
Spray
Only
fig. 14

Cleanser:

™
™
™
5