Physical Description; Ethernet Connector; Usb Host Ports; Init Button - Digitus DN-13007 User Manual

2 usb 2.0 hi-speed ports/mfp server

Hide thumbs Also See for DN-13007:

Table of Contents

2.3

Physical Description

2.3.1

The network connector of this Server is designed for 10 Mbps or 100 Mbps Ethernet

networks and connects to the network via a twisted pair category 5 cable (10baseT

and 100baseTX) or better.

2.3.2

This Server has two USB host ports which are USB 1.1/2.0 low, full, and high speed

compliant and successfully tested with USB 1.1/2.0 printers, Mass Storage, and

AIP/MFPs.

2.3.3

The Init button is used for:

performing a Factory Default of the Server, which will restore most of the

parameters and settings to factory default values

performing the new firmware upgrade using in fallback

2.3.4

Power Indicator is lit while power is applied. If it is not lit, or if it blinks, there

is a problem with MFP server or Power Adapter.

Link Status is lit while network is applied. If it is not lit, it indicates that the

server does not connect to network.

Status Indicator blinks to indicate network activity.

USB1 Indicator is lit while an USB device connects to USB1 Port of MFP server.

If it is not lit, or if it blinks, there is a problem with the USB device or the MFP

server.

USB2 Indicator is lit while an USB device connects to USB2 Port of the MFP

server. If it is not lit, or if it blinks, there is a problem with the USB device or

the MFP server.

Table of Contents