Fisher & Paykel Wall Oven User Manual page 39

CAKE IS FALLEN IN THE CENTER
CAUSE
Baking temperature too low.
Opening the door too early in baking.
Baking time too short.
Proportions of ingredients incorrect.
BAKED PRODUCTS TAKING TOO LONG TO COOK
CAUSE
Shelf position too low.
Temperature too low.
Baking tin the wrong size.
Incorrect mode e.g. Pastry Bake.
FAULT CODES
If a fault occurs, the oven will 'beep' every second and a fault code will appear in the clock display as a letter 'F' with a number after it.
Depending on the nature of the fault, it may be possible to clear the display by pressing the PUSH TO CLEAR button. If the fault code
and continuous 'beep'cannot be cleared this way, note down the fault code and switch the oven off at the main power supply. In either
event, please call your Fisher & Paykel Authorized Service Center and advise them of the fault code. This information will help them to
resolve the problem. If you have any questions about operating the product, please contact our Fisher & Paykel Customer Care Center.
HOW TO CHANGE THE OVEN LIGHT BULBS
The oven is illuminated by 3, 12 volt, 20 watt halogen bulbs. These have a very long life, but if you should need to replace one, turn the
oven off and allow it to cool. Take out the shelves and use a small flat head screwdriver to twist and lift the retaining clip at the top of
the glass light cover. The clip pivots counter clockwise (see the diagrams below). Carefully lift the glass cover out of the lower support.
Pull out the faulty bulb and, holding it in a soft cloth or tissue (touching the bulb will reduce its life span), insert the replacement. The
two pins are vertically orientated. Reposition the glass cover and twist the top clip back in place. The procedure is the same for the
light in the roof of the oven cavity.
pivoted bracket
plate glass cover
REMEDY
Try a higher temperature.
Do not open the door until at least
a sudden burst of cold air can make cakes sink in the middle.
Increase cooking time.
Check recipe.
REMEDY
Try a higher shelf position.
Try a higher temperature.
Use pan/tin size stipulated in recipe. Baking time varies not only with
oven temperature and baking utensil material but also by utensil size.
Try changing to an Aero
distribute heat more evenly; they also increase the rate of browning.
Use a flat-head screwdriver to turn the
bracket and free the plate glass cover.
Carefully install the new lightbulb by inserting into the
vertical sockets as shown.
3 / 4
of the cooking time has passed:
TM TM
mode. Aero modes speed up cooking and
37