IBM ThinkCentre 8127 Hardware Maintenance Manual page 42

Figure 2. Microprocessor
10. Remove the microprocessor 2 from the system board by lifting the small
11. Carefully take note of the location of all cable connections on the system
12. Take note of the cable routing. It is important to route the cables properly
13. Disconnect the diskette drive cable from the system board by sliding the
14. Disconnect all other cables connected to the system board.
36
Hardware Maintenance Manual
handle 1 on the microprocessor. Carefully lift the microprocessor out of the
socket.
v If you are installing a new system board assembly, continue at Step 11.
v If you are replacing only the microprocessor, go to "Replacing the
microprocessor" on page 38.
board. It will be necessary to reconnect them properly when installing a new
system board assembly.
when installing the new system board.
plastic cable retainer upward to release the cable.
1
Microprocessor heat sink
2
Fan connectors (2)
3
memory module connectors (2)
4
SATA 1 IDE and SATA 2 IDE
connectors (2)
5
PCI riser connector
6
Speaker connector
7
POV connector
8
Diskette drive connector
9
Front panel connector
10
Power connector (P1)
11
PATA Primary IDE connector
12
Power connector (P2)
13
Heat sink clamps
14
CD audio connector