Fujitsu ESPRIMO E4xx Operating Manual page 46

System expansions
Removing an accessible 3 / inch drive (multicard reader) or
1
2
an inaccessible 3 / inch drive (hard disk)
1
2
► Remove the cover (see chapter "Removing a cover", Page 33).
► Remove the front panel (see chapter "Removing the front panel", Page 34).
► Remove the drive cage (see chapter "Removing the drive carrier", Page 37).
► Disconnect all cables connected to the drive (data cable, power supply cable).
► Turn the drive cage over.
1
1
1
2
► Remove the screws (1).
► Pull the drive out of the drive cage in the direction of the arrow (2).
► Install the drive cage (see chapter "Installing the drive cage", Page 38).
► Secure the front panel on the casing (see chapter "Securing the front panel", Page 35).
► Install the cover on the casing again (see chapter "Reattaching the cover", Page 36).
It may be necessary to modify the entry for the drive in the BIOS Setup.
42 Fujitsu