Hearth Requirements And Floor Protection; Rotation Lock Install Procedure - HearthStone hase lima 8150 Owner's Manual

H R
EARTH EQUIREMENTS
P
ROTECTION
Ensure you protect combustible flooring with a
covering of a noncombustible material. The floor
protection must extend beyond the body of the
stove at the minimum as follows:
In Figures 1 and 2 you will find two hearth options;
one hearth for the freely rotating stove and the other
for the locked stove.
Installations in Canada require 18" (45.72 cm) of floor
*
protection on both side and front.
** Rear clearance required only if stovepipe runs horizontally
back above the top of the stove.
2"
39 1/2"
[5CM]
[100CM]
(U.S.)
16"
[41CM]
(U.S.)
16"
[41CM]
(U.S.)
51"
[130CM]
US
HEARTH PAD MAY BE
RADIUSED FROM FRONT EDGE
FLOOR PROTECTOR
STOVE CAN ROTATE
180 DEG.
Figure 1
2"
[5CM]
1
4 2"
[12CM]
35"
[89CM]
(U.S.)
16"
Measured
[41CM]
from glass
(U.S.)
28"
[71CM]
HEARTH PAD MAY BE
RADIUSED FROM FRONT EDGE
Floor protection for stoves only
in the locked position shown
Figure 2
Hearthstone Quality Home Heating Products, Inc ®
A F
ND LOOR
2"
[5CM]
18"
[46CM]
CAN
41 1/2"
[105CM]
CAN
18"
Measured
[46CM]
from glass
CAN
55"
140CM
CAN
2"
[5CM]
1
4 2"
[12CM]
37"
[94CM]
(CAN.)
18"
[46CM]
(CAN.)

Note: Dimensions shown in previous figures
are from the body of the stove.
The Lima wood stove has a unique feature that
allows it to rotate. This rotation allows positioning the
body of the stove into 13 different positions, up to a
full 90 degrees to either side. In order to install the
Lima onto the smaller hearth protector shown in
Figure 2, you must lock the stove in place. To do
this, follow the instructions below:
R L
OTATION OCK
1. Open the lower control door and locate the
rotation control.
2. Ensure the
orientation (line up the index marks) and
then position the stove to center the door on
the hearth.(see fig. 3)
3. Press the control lever and release. Using a
13mm wrench, remove the hex screw at the
base of the control knob and washer (see
fig. 4).
4. Rotate the stove body very slightly. Slide the
Locking Stopper down through the hole on
the deck of the control knob. Be sure the
Stopper slides all the way into place over the
matching groove (see fig. 5).
5. Rotate the stove back to the zero position.
Rotate the stove in the opposite direction as
Step 4 slightly. Slide the second Locking
Stopper down into place (see fig. 6).
6. Rotate the stove back to the zero position
and replace the Control knob (see fig. 7).
Figure 3 - Zero Index Marks
8
I P
NSTALL ROCEDURE
stove is in its 0-degree
Lima Model 8150