DCL-200 FD
Troubleshooting
Problem
Check
Projector does not start
Projector power cord is not plugged into the wall outlet.
Remote control batteries need replacing.
No picture
The selected projector input mode is wrong. Select TV/Projector then HDMI 1
HDMI cable may be incorrectly connected to the rear panel of the projector.
Check power to the external devices, including ProScaler.
The video signal format of the video equipment is not set correctly.
Color is faded
Picture adjustments are incorrectly set.
Picture is blurred
Adjust the projector focus.
The projection distance exceeds the focus range.
Picture noise appears
(Component/VGA input only)
Perform Fine Sync adjustments ("Clock" adjustment) also in Component.
Perform Fine Sync adjustments ("Phase adjustment) also in Component.
Picture is green on INPUT1 COMPONENT
Change the input signal type of the video equipment.
Picture is dark
Picture adjustments are incorrectly set.
Picture is too bright and whitish
Picture adjustments are incorrectly set.
45