InTroduCTIon Wolf Cinema’s DCX line of projectors are designed to work in conjunction with the WC-Pro Scaler. The Scaler is calibrated at the factory and is to be used to route the variety of inputs it supports; 6 HDMI, 1 Component, 1 Component/RGB, 1 S-Video and 1 Composite Video.
HDMI 2 HDMI 3 HDMI 4 HDMI 5 Video / Audio Audio IR Control AC Input 110-240V, 50/60Hz Component 2 / RGBHV noTe: If RS-232 is being used to control the Scaler, GPIO is not used. Wolf Cinema Quick Setup Guide...
The VariScope Lens System must be selected for this feature to operate and is enabled at the factory. If the feature is disabled, it can be re-enabled in the Geometry and Color sub-menu located within the Display Setup menu. Wolf Cinema Quick Setup Guide...
Highlight the desired channel and select the Enter button. The “Channel Edit” OSD will appear. Scroll to the second slot that shows “Number” and select the Enter button. Select the desired number location by entering it onto the remote control keypad. Wolf Cinema Quick Setup Guide...
HDMI 4 Channel 66 COMP 1 Channel 99 VIDEO noTe: When using RS-232 control, all channels can be used for any aspect ratio. noTe: The GPIO Channel Memory Structure is used only when GPIO is enabled. Wolf Cinema Quick Setup Guide...
Page 9
Wolf Cinema . 2431 Fifth Street . Berkeley . CA 94710 . Ph: 510.843.4500 . Fax: 510.843.7120 . www.wolfcinema.com...
Need help?
Do you have a question about the DCX-500i and is the answer not in the manual?
Questions and answers