Table of Contents
Advertisement
DCL-200 FD
Setting up the Screen
Position the projector perpendicular to the screen with all feet flat and level to achieve an optimal image.
Note: • The projector lens should be centered in the middle of the screen. If the horizontal line passing through the lens center
is not perpendicular to the screen, the image will be distorted, making viewing difficult.
• For an optimal image, position the screen so that it is not in direct sunlight or room light. Light falling directly on the
screen washes out the colors, making viewing difficult. Close the curtains and dim the lights when setting up the
screen in a sunny or bright room.
• A polarizing screen cannot be used with this projector.
Standard Setup (Front Projection)
Place the projector at the required distance from the screen according to the desired picture size.
An Example of Standard Setup
90
23
23
23
V
V V
40
40
40
1 1
1
2
2 2
18
1080p DLP LED Front Projector
H H H
H
H H
• The distance from the screen to the projector may
vary depending on the size of the screen.
• Set the projector in front of the screen. If the
projected image is reversed or inverted, readjust
the setting to Front for Image Orientation in
the Display Setup menu.
Audience
• Place the projector so that an imaginary horizontal
line that passes through the center of the lens is
perpendicular to the screen.
Note: 2D Lens Shift Ability:
• Short throw lens shift:
1/2 of screen height: Up 120%, Down 50%
1/2 of screen height: Left 15%, Right 15%
• Long throw lens shift:
1/2 of screen height: Up 120%, Down 50%
V
V V
1/2 of screen height: Left 15%, Right 15%
• It is recommended that images be
projected onto the dashed line octagonal
area for fine image quality.
• There is a tolerance of ±5% in the
formula above.
User's Manual
Advertisement
Table of Contents
