Common Pool Problems - Intex Krystal Clear SF90110T Owner's Manual

COMMON POOL PROBLEMS

PROBLEM DESCRIPTION
ALGAE • Greenish water.
• Green or black spots
on pool liner.
• Pool liner is slippery
and/or has a bad odor.
COLORED • Water turns blue,
WATER brown, or black
when first treated
with chlorine.
FLOATING • Water is cloudy or
MATTER IN milky.
WATER
CHRONIC LOW • Level is lower than
WATER LEVEL on previous day.
SEDIMENT ON • Dirt or sand on pool
POOL BOTTOM floor.
SURFACE • Leaves, insects etc.
DEBRIS
If you continue to experience difficulty, please contact our Consumer Service Department for
assistance. See separate "Authorized Service Centers" sheet.
SAVE THESE INSTRUCTIONS
(193PO) MODEL SF90110T SAND FILTER PUMP ENGLISH 7.5" X 10.3" PANTONE 295U 06/21/2013
CAUSE
• Chlorine and pH levels
need adjustment.
• Copper, iron or maganese
in water being oxidized by
the added chlorine.
This is Common.
• "Hard water" caused by a
too high pH level.
• Chlorine content is low.
• Foreign matter in water.
• Rip or hole in pool liner or
hoses.
• The drain valves are loose.
• Heavy use, getting in and
out of pool.
• Pool too close to trees.
IMPORTANT
English
SOLUTION
• Super chlorinate with shock
treatment. Correct pH to your
pool store's recommended level.
• Vacuum pool bottom.
• Maintain proper chlorine level.
• Adjust pH level to the
recommended level.
• Run filter until water is clear.
• Correct the pH level. Check with
your pool dealer for advice.
• Adjust the chlorine level.
• Repair with a patch kit.
• Finger tighten all caps.
• Use Intex pool vacuum to clean
of pool.
• Use Intex pool skimmer.
Page 21
193
PO