Table of Contents
Advertisement
Image Capture function
1. Auto Capture: If the door chime is activated by a visitor but no one replies from
any of the monitor units, the system will take an image of the visitor and store it for
later viewing. Up to 64 images, with date/time stamp, can be stored. When image
storage is full, the oldest image is deleted each time a new image is added.
2. Manual Capture: When you monitor an image or talk with a visitor at the door
station, press the "Menu/Set button. The message "IMAGE CAPTURED" will appear
on the screen indicating that the visitor's image has been successfully captured.
Press "Menu/Set" while in standby mode to view the last captured image.
Use the "Prev" or "Next" buttons to view other images.
Using an SD Card for image storage
Images are normally stored using the on-board memory however images can also be
stored on a removable SD card allowing images to be transferred to a personal
computer.
The maximum capacity of SD card is not to exceed 1 GB
The SD card must be formatted using the "Image Delete" process in the Photo Set
menu.
IMPORTANT NOTE:
Do not format the SD card on a personal computer as the SD card will no longer be
suitable for use with the intercom and will need to be replaced with a new card.
The SD card must only be formatted using the "Image Delete" process in the Photo Set
menu.
How to activate the Do Not Disturb function?
When you don't want to be disturbed by the chime from an indoor monitor, you can
activate the Do Not Disturb function. There will be no sound from the monitor when
the doorbell is activated or when an all station call is initiated. The chime will only
sound when the monitor receives an individual call from another monitor where the
call has been initiated using the appropriate "NUMBER" button.
Activation procedure:
In standby mode, press the "Monitor" button for 2 seconds at any indoor monitor.
"No Disturb Mode On" will appear on the screen. In Do Not Disturb mode, the
monitor can still see the image from the front door and can still answer the call.
Do Not Disturb mode can be deactivated by once again pressing the "Monitor" button
for 2 seconds while in standby mode. "No Disturb Mode Off" will appear on the
screen.
22
25
Advertisement
Table of Contents
