Oscillator - IBM EM78P809N Specification

When one of the interrupts (enabled) occurs, the next instruction will be fetched from
individual address. The interrupt flag bit must be cleared by instructions before leaving
the interrupt service routine and before interrupts are enabled to avoid recursive
interrupts.
The flag (except ICIF bit) in the Interrupt Status Register (ISFR 2) is set regardless of
the status of its mask bit or the execution of ENI. The RETI instruction ends the
interrupt routine and enables the global interrupt (the execution of ENI).

4.16 Oscillator

4.16.1
The EM78P809N can operate in two different oscillator modes, i.e., Crystal oscillator
mode and External RC oscillator mode (ERC) oscillator mode. User can select which
mode by Code Option Register. The maximum limit for operational frequencies of the
crystal/resonator under different VDDs is listed below.
Table 10 Oscillator Modes Defined by SDCS and OSC
Table 11 The Summary of Maximum Operating Speeds
High frequency oscillator
4.16.2
EM78P809N has a clock generator. i.e. Fc (high frequency) which can be driven by an
external clock signal through the OSCI pin.
In most applications, Pin OSCI and Pin OSCO can be connected with a crystal or
ceramic resonator to generate oscillation. Table 12 provides the recommended values
of C1 and C2. Since each resonator has its own attribute, user should refer to its
specification for appropriate values of C1 and C2.
necessary for AT strip cut crystal.
Product Specification (V1.0) 07.26.2005
(This specification is subject to change without further notice)
Oscillator Modes
Mode
Single Clock
Condition
Crystal Oscillator/Ceramic Resonators (Crystal)
8-Bit Microcontroller
OSC
1 High frequency oscillator
0
VDD Max. Fxt. (MHz)
3.0
5.0
A serial resistor Rs may be
EM78P809N

Oscillator

ERC
4.0
10.0
• 55