I/O Ports; Reset And Wake-Up - IBM EM78P809N Specification

4.13 I/O Ports

The I/O registers, Port 6, Port 7, Port 8, and Port 9 are bi-directional tri-state I/O ports.
Each I/O pin can be defined as "input" or "output" pin by the I/O control register (IOC6 ~
IOC9). The I/O registers and I/O control registers are both readable and writable. The
I/O interface circuits for Port 6, Port 7, Port 8, and Port 9 are shown in Fig. 27.
PORT

4.14 RESET and Wake-up

4.14.1 RESET
A RESET is initiated by one of the following events:
(1) Power-on reset
(2) /RESET pin input "low"
(3) WDT timeout. (if enabled)
The device is kept in a RESET condition for a period of approx. 18ms
start-up timer period) after the reset is detected. Once a RESET occurs, the following
functions are performed.
The oscillator starts or is running
The Program Counter (R2) is reset to all "0".
When power is switched on, the upper 2 bits of R3, the upper 2 bits of R4 and the
bits 6 ~ 4 of R5 are cleared.
All I/O port pins are configured as input mode (high-impedance state).
1
NOTE: V = 5V, set up time period = 16.2ms ± 30%
DD
V = 3V, set up time period = 19.6ms ± 30%
DD
Product Specification (V1.0) 07.26.2005
(This specification is subject to change without further notice)
0 M
U
1
X
Fig. 28.The I/O Port and I/O Control Register Circuit
PCRD
P
Q
D
R
PCW R
CLK
C
Q
L
P
Q
D
R
PDW R
CLK
C
Q
L
PDRD
EM78P809N
8-Bit Microcontroller
IOD
1
(one oscillator
• 47