Acculab GSI-200 Instruction Manual

ACCULAB
Limited Warranty
Effective Date: January 1, 2003
Standard Terms and Conditions
Models: GSI series
ACCULAB warrants the product series "GSI" against defects in material and
workmanship to the original consumer for a peroid of twelve (12) months or
a maximum of fifteen (15) months from date of sale to authorized ACCULAB
distributor. The warranty includes parts, labor and return shipping charges to
customer (ground freight).
This specific warranty shall not apply to any product damaged due to accident,
misuse, abuse, lightning strike, power surges, improper packaging for shipment to
ACCULAB, or service/modification by anyone other than an authorized ACCULAB
Technician.
The purchaser's sole remedy, ACCULAB and its suppliers sole liability are set forth
herein. In no event shall ACCULAB or its suppliers be liable for any damages,
incidental or consequential, expenses, lost profits, lost savings, or any other claims
due to the use or inability to use the product/s. ACCULAB shall limit its obligations
under warranty to a time not to exceed the original product warranty period set
forth herein. This warranty gives you specific legal rights and you may have other
rights, which may be different from state to state.
In the event that service is required, the Customer/Distributor should call
ACCULAB (800-656-4400, extension 8342) for proper return authorization. The
product must be delivered to ACCULAB, Service Division 6542 Fig Street, Arvada,
CO., 80004 within the warranty period, freight charges prepaid. The customer is
responsible for product removal, installation and proper packing in order to
prevent damage while shipping to ACCULAB Service facility.
This limited warranty supersedes all other warranties pertaining to the ACCULAB
products, whether expressed or implied. Claims may be made by calling 800-656-
4400/631-254-4299, by fax 800-356-0338/631-253-5472, or in writing to:
ACCULAB
Attn: Warranty Administrator
6542 Fig Street
Arvada, CO., 80004
(800-656-4400)

ERROR CODE

Following is a description of typical error codes that may appear on
GSI-Series balances.
1) L This indicates that the balance is under loaded. Check to see
if the weighing pan is properly installed and seated on the top of
the unit. Performing the calibration procedure may cure this prob-
lem, otherwise, contact Acculab for repair.
2) H This indicates that there may be an excessive weight applied
to the weighing pan. It is critical not to exceed the maximum load
capacity by more than 150% or damage to the balance may occur.
This may also be an indication that the unit needs to be calibrated.
Performing the calibration procedure may cure this problem, other-
wise, contact Acculab for repair.
3) ER 56 This code refers to an error generated due to a sensor
problem. The most common cause is from objects being dropped
onto the weighing pan or from the balance itself being dropped.
Contact Acculab for repair.
4) ER 57 This code occurs when the electronics are no longer
within the factory set parameters. The most common cause is from
rough or improper handling of the balance. Contact Acculab for
repair.
Specifications subject to change without notice.
as applicable
INSTRUCTION
PLEASE READ COMPLETE
INSTRUCTIONS BEFORE USE
R
R
MANUAL
M
odel
#GSI-200
#GSI-2001