Brother MFC-8510DN Basic User's Manual page 98

Error Message
Fuser Error
Jam Duplex
Jam Inside
Jam MP Tray
Jam Rear
Jam Tray 1
Jam Tray 2
Limit Exceeded
Log Access Error
Manual Feed
No HUB Support
No Paper
No Response/Busy
90
Cause
The temperature of the fuser
unit does not rise to a specified
temperature within the
specified time.
The fuser unit is too hot.
The paper is jammed in the
duplex tray or the fuser unit.
The paper is jammed inside the
machine.
The toner cartridge is placed in
the machine without the drum
unit.
The paper is jammed in the MP
tray of the machine.
The paper is jammed in the
back of the machine.
The paper is jammed in the
paper tray of the machine.
The number of pages you are
allowed to print has been
exceeded. The print job will be
cancelled.
The machine could not access
the print log file in the server.
Manual was selected as the
paper source when there was
no paper in the MP tray.
A USB hub device is
connected to the USB direct
interface.
The machine is out of paper in
the specified tray or all trays, or
paper is not correctly loaded in
the paper tray.
The number you dialled does
not answer or is busy.
Action
Turn the power switch off, wait a few seconds,
and then turn it on again. Leave the machine
idle for 15 minutes with the power on.
See Paper is jammed in the duplex tray
uu page 106.
See Paper is jammed inside the machine
uu page 102.
Put the toner cartridge into the drum unit, and
then re-install the drum unit and toner cartridge
assembly in the machine.
See Paper is jammed in the MP tray
uu page 97.
See Paper is jammed at the back of the
machine uu page 99.
See Paper is jammed in paper tray 1 or tray 2
uu page 98.
Contact your administrator to check your
Secure Function Lock Settings.
Contact your administrator to check the Store
Print Log to Network settings.
For detailed information uu Network User's
Guide: Store Print Log to Network
Place paper in the MP tray. If the machine is in
Pause mode, press Start.
(See Loading paper in the multi-purpose tray
(MP tray) uu page 12.)
Disconnect the USB hub device from the USB
direct interface.
Do one of the following:
Refill paper in the paper tray shown on the

LCD. Make sure the paper guides are set to
the correct size.
 Remove the paper and load it again. Make
sure the paper guides are set to the correct
size.
Verify the number and try again.