Rear Facing Mode Using Lap/Shoulder Belt (Type Ii) - Peg-Perego Primo Viaggio SIP Convertible Instructions For Use Manual

REAR FACING MODE USING LAP/
SHOULDER BELT (TYPE II)
1. Recline the child restraint to the rearfacing
position as shown in the picture. To recline
the child restraint, pull the handle located
below the front edge of the shell (A) as shown
in detail. An audible "click" is heard when the
seat is properly locked into position.
2. Disengage the rebound bar under the seat
and rotate it until it clicks in position as shown
at page 24. Lean the reclined child restraint,
unoccupied, on the selected vehicle seat.
3. Pull the vehicle belt at full available length
and thread both the lap and shoulder portion
of the belt through the openings under the
seat area as shown in
the picture.
IMPORTANT: check inside
the shell openings; verify
that the waist position of
the belt is placed as shown
in the picture.
Installing your child restraint in the vehicle
A
B
- 27 -
1
A
2
3