Clifford Responder LE 3.3X Installation Manual page 70

2-5 IGNITION CONTROLLED DOME LIGHT SUPERVISION ON: If turned on, the
system will turn on the dome light for 60 seconds when the ignition is turned
off. The optional dome light supervision feature must be installed as described
in the Wire Connection Guide. Use the two-chirp setting for: Ignition controlled
dome light OFF.
2-6 FAD w/channel 2 ON: FAD w/channel 2 OFF. In the default setting the fac-
tory alarm disarm output will disarm the factory alarm system any time the but-
ton controlling the trunk release output is pressed.
2-7 FACTORY ALARM DISARM-WITH UNLOCK, BEFORE UNLOCK, REMOTE START
ONLY: In the default setting the factory alarm disarm output will disarm the factory
alarm system any time the button controlling Unlock or Remote Start is pressed.
The "Before Unlock" output will disarm the factory alarm before the unlock output
activates and when remote start is activated. The "Remote Start Only" will disarm
the factory alarm only when the remote start is activated.
2-8 FAD 1 pulse: FAD 2 pulses. This setting determines how many pulses the
security system will output on the Factory alarm disarm wire.
2-9 Channel 1 Validity (1) Latched (2), Latch reset w/ignition (3), 30-sec.
timed (4)
Validity: Output that will send a signal as long as the transmission is

received.
 Latched: Output that will send a signal when the Channel 1 button(s) is
pressed and will continue until the same button(s) is pressed again.
Latched, reset with ignition: Similar to the latched output this output type

turns ON the first time the Channel 1 button (s) is pressed and turns OFF the
next the same button is pressed. This output type additionally stops and resets
whenever the ignition is turned ON, and then OFF.
30-second timed: Output that will send a continuous signal for 30 seconds.

 Off: Output is disabled.
Note: All auxilary channel timed outputs can be programmed using the Bitwriter®
(1-90 seconds)
0
© 2008 Directed Electronics—all rights reserved