Table of Contents
Advertisement
Wire connection guides
Primary harness (H1)
H1/1 RED/WHITE Aux/Trunk release , 200mA (-)
outputt
When the system receives the code controlling trunk release output for longer
than 1.5 seconds, the red/white wire will supply an output as long as the trans-
mission continues. This is typically used to operate a trunk/hatch release or other
relay-driven function.
Important! Never use this wire to drive anything but a relay or a low-current
input! The transistorized output can only supply 200mA of current. Connecting
directly to a solenoid, motor, or other high-current device will cause it to fail.
H1/2 RED (+)12V Constant power input
Before connecting this wire, remove the supplied fuse. Connect to the battery
positive terminal or the constant 12V supply to the ignition switch.
Note: Always use a fuse within 12 inches of the point you obtain (+)12V. Do not
use the 15A fuse in the harness for this purpose. This fuse protects the module
itself.
24
© 2008 Directed Electronics—all rights reserved
Hide quick links:
Advertisement
Table of Contents
