Heavy Guage, 10-Pin Connector - Clifford Responder LE 3.3X Installation Manual

Heavy Gauge, 10-pin connector
There are 9 heavy gauge wires coming from the large 10-pin connector. They are
used to energize the ignition circuits in the vehicle. It is crucial that these con-
nections are well made and capable of handling the current demands. For this rea-
son, Scotch-Locks, T-taps and other such connectors are strongly discouraged.
H3/1 PINK – (+) Ignition 1 input/ output
Connect this wire to the ignition wire in the vehicle. This wire not only supplies
voltage for the ignition line in the vehicle, it is also the ignition feed for the
security system.
H3/2 RED/WHITE – (+) 30a fused ignition 2/flex relay, pin 87, input
This wire is the polarity feed for the ignition 2/flex relay.
H3/3 ORANGE – Accessory output.
Connect this wire to the accessory wire that powers the climate control system
H3/4 VIOLET – Starter output.
This wire hooks up to the starter side of the starter wire in the car. This wire is
also pin 30 of the onboard starter kill relay.
H3/5 GREEN – Starter input.
After cutting the starter wire connect the GREEN wire to the end going to the
ignition switch. This wire is pin 87a of the onboard starter kill relay.
H3/6 RED – 30 amp fused Ignition 1 relay input.
This wire is the polarity feed for the Ignition 1 relay.
H3/7 PINK/WHITE – Ignition 2 flex relay output.
This wire is factory programmed as Ignition 2 and can be programmed as a 2nd
accessory or 2nd starter.
44
© 2008 Directed Electronics—all rights reserved
.