Accent Light Replacement - Lopi Cypress GSR Owner's Manual

Maintenance

Accent Light Replacement

An accent light is included in your stove to provide additional lighting. To replace the bulb, follow the directions
below:
•
Disconnect stove from power. Shut off gas to the stove. Make sure the stove is cool before proceeding (15
minutes).
•
Remove the stove top and place it aside (see page 23).
•
Remove the four screws securing the accent light cover. Place the cover to aside.
•
Remove the two screws securing the accent light assembly. Place the assembly upside down on the firebox top,
making sure the wiring is not damaged or dislodged. When replacing, make sure the glass is aligned below the
assembly.
Loosen the two screws nearest the bulb to disengage the bulb from the holder. Remove the bulb from
the holder. Replace the bulb, making sure not to touch the bulb with your fingers (grasp the bulb with the
bulb packaging or a paper towel). Tighten the screws until the bulb is secure (do not over-tighten, this
may damage the electrical contacts on the bulb).
© Travis Industries
(for authorized service personnel only)
4121109
35
100-01329.docx