Manual Setup - IBM T84H Setup Manual

T84H_setup0926_final.fm Page 13 Thursday, October 5, 2000 8:45 AM
If the monitor is in standby
mode (STANDBY ON), it
might automatically turn off
while you are waiting for it to
warm up.
Normally, you can complete the setup procedure using
if your screen image is still distorted after you perform
setup diskette does not run on your system, perform
1. Have your monitor turned on for about 15 minutes, until the monitor
warms up.
2. Display the image you most frequently use on the screen.
3. Press the OSD Enter button
the initial OSD menu.
4. Use an Arrow button (
and press the OSD Enter button
5. Using an Arrow button (
press once to select
indicators become illuminated (see page 18
6. Use the Arrow buttons to manually adjust to correct (as much as
possible) for noise in the video signal then press
changes.
7. Use an Arrow button to select
8. Use the Arrow buttons again to tune the image to your liking.
9. When finished, press the Exit button
OSD.
You have completed the monitor setup.

Manual Setup

A
M
ANUAL
at the bottom of the monitor to display
or ) to select the IMAGE LOCK icon
to access the function.
or ), select
MANUAL
. Left and right arrow adjustment
COARSE
).
and press the
FINE
four times to exit from the
, however,
A S
UTO ETUP
or the
S
UTO ETUP
.
S
ETUP
, press and then
to save the
button.
13