Switching On Your Monitor - IBM T84H Setup Manual

T84H_setup0926_final.fm Page 6 Thursday, October 5, 2000 8:45 AM

Switching on your Monitor

6
4. Connect the DVI connector at the end of the signal cable to the DVI port
located on the back of the Monitor. See above picture.
5. Connect the DVI connector at the other end of the signal cable to the
DVI port located on the back of the graphics adapter. See picture below.
6. Replace the rear covers.
7. Connect the power cord to the power adapter first, then insert the plug
into a properly grounded electrical outlet.
8. Switch on the power source and your computer. To turn on the monitor,
push and release the power switch
the power switch again.
1. Switch on the power source and your computer.
2. Switch on your monitor by pushing and releasing the power switch
marked .
To switch off your monitor, push and release the power switch again.
3. Turn on the monitor and then the computer.
4. Run by following the instructions in the Configuring your
A S
UTO ETUP
Monitor section on page 7.
graphics adapter
DVI
Signal Cable
. To switch it off, push and release